The main points of the design of conventional plating hangers

What are the main points of the conventional plating hanger design:

①The material used to make the hanger should be stable and insoluble in the solution.

②There should be good contact measures between the hanger and the plated parts and the pole, especially the hanger with light-weight parts.

③The main pole and support pole combination hanger should not be connected by riveting, so as not to store the solution.

④Reliable insulation measures must be considered for the cathode and anode combination hangers.

⑤The hanging direction of the workpiece should be fully considered, especially the sharp corners and deep concave parts.

⑥Sufficient anode area and related requirements should be considered in the plating cavity of cylindrical workpiece.

⑦The design of the hanger should fully consider the versatility. Reduce the repeated design of similar parts using hangers.

⑧Ensure the current intensity that the hanger needs to pass when working. In case the cross-sectional area is too small to affect the normal flow of current.

⑨Convenient loading and unloading must be considered for all hangers.

⑩In addition to the parts in contact with the workpiece, insulation measures must be taken into consideration for other parts of the hanger.

⑾The mounting hanger must be firm and reliable, and the workpiece will not fall off the hanger during the whole process.

⑿It must be able to withstand the weight requirements of the workpiece to be hung, and it will not be deformed due to this.

⒀Because the covering surface of the hanger is too large, it will not affect the normal deposition of the coating.

⒁Consider whether there are mounting marks after the workpiece is mounted.